Leon Promet wrote:

Hi Finn,

I'm not familiar with your carb and manifold setup.  Do you have a picture.
 Also,  I need to know what sort of ignition set-up you have.  Sounds like
some sot of ignition cross fire.  Can't prognosticate any more until I see
what you have.

Can I also assume that you have a water 'pressure' gauge as well as a temp
gauge? Is it mechanical or electric.  The pump always produces pressure.
 It is VERY rare, but I have seen an impeller slip on the pump shaft,  so I
would at least be replacing the pump.  Water pressure should not go to
zero!

Leon Promet

Finn Lassen wrote:

I've got three Mikuni (bike) carbs in line. Separate (outer) carbs for each
rotor. Center carb feeds both rotors. One throttle regulates outer carbs, other
throttle the center carb. One pump feeds outer carbs, another pump the center
carb.

All gauges are electrical, including water pressure.

Don't have a good photo available, only this.

Finn

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org