Subject: Gull wing doors leaks.
From: Paul
Date: 1/13/2001, 5:25 PM

I was talking to Bill Grote about what changes he would make in the 
Kis Cruiser. He said the gull wing doors leak. If they don't leak
while it is raining they dump a lot of water when you open them
right on the control stick and the seat. I thought about it
for awhile and this is what I came up with. You need to make
this part before the top fuselage is bonded onto the bottom fuselage
and you can turn it upside down. It does not required any changes 
in the fuselage mold.

Use a strip of plastic about three inches wide all around the door opening
to serve as a parting agent. Use mold wax to make the bump which
will later become the water drain channel. I suggest making it from two or 
three layers of four ounce bi-di.  After it is cured you can
bond it to the door frame and drill a bunch of small weep holes in strategic
locations. Should stiffen the door frame a bit more too.
The rubber seal shown is not porous and it is bonded to the door frame
and not the door. Subtle but important point.

I am uploading this here because the Kis list don't take 
graphics and I am sure Vance, and Bill Schertz will make sure it gets
to the right places. I'll put it up on my web site Kis division eventually. 
In the mean time if anybody wants to put it on any Kis web sites feel free.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org