Subject: Gull wing doors leaks.
From: Paul
Date: 1/13/2001, 7:01 PM


 I was talking to Bill Grote about what changes he would make in the
 Kis Cruiser. He said the gull wing doors leak. If they don't leak
 while it is raining they dump a lot of water when you open them
 right on the control stick and the seat. I thought about it
 for awhile and this is what I came up with. You need to make
 this part before the top fuselage is bonded onto the bottom fuselage
 and you can turn it upside down. It does not required any changes
 in the fuselage mold.

 Use a strip of plastic about three inches wide all around the door opening
 to serve as a parting agent. Use mold wax to make the bump which
 will later become the water drain channel. I suggest making it from two or
 three layers of four ounce bi-di.  After it is cured you can
 bond it to the door frame and drill a bunch of small weep holes in
strategic
 locations. Should stiffen the door frame a bit more too.
 The rubber seal shown is not porous and it is bonded to the door frame
 and not the door. Subtle but important point.

 I am uploading this here because the Kis list don't take
 graphics and I am sure Vance, and Bill Schertz will make sure it gets
 to the right places. I'll put it up on my web site Kis division
eventually.
 In the mean time if anybody wants to put it on any Kis web sites feel free.

 Paul Lamar



Paul,
Nice Idea -- I am forwarding it to Bob Reed to put on his web site.
Bill

Bill Schertz
KIS Cruiser #4045

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org