Subject: Question Re: pocofoam - Wing cooling
From: Paul
Date: 1/13/2001, 6:59 PM


Robert Barnard wrote:

 Here is a far out question.

 There have been a few attempts to cool an engine by dissipating the
heat to
 the skin of the aircraft.  Could this be a viable alternative to a
 drag-inducing radiator?


James Russell wrote:

After the Italian seaplane racer in the '30s, Porsche tried surface
coolers since their
bodywork was already alumnium by welding half-tubes to the bottom side
of it.
I think the cracking and leaks stopped them.

Porsche will try anything: annular brakes, alumnium tube-frames,
electron beam
welding cranks together...

 > Would pocofoam work well to distribute heat from a rigid tube to
the outer
 skin of a wing or fuselage and be light and efficient?

 > RB


The skin-to-PocoFoam part is what I'm curious about: alumnium
(corrosion),
brass/copper (heavy), carbon ( the fibers run normal to the PocoFoam
plus it needs
350s cure epoxy which means a tool and oven), ? I emailed them about
this, tho.

Regards,
James

Robert Barnard wrote:

Electrolysis would be a definite problem to workout, assuming it?s necessary
to dissipate through aluminum skin.  If aluminum were part of the answer, a
thermally efficient bonding agent would be employed.  It or other material
(light fiberglass cloth) could be a barrier between the carbon and aluminum.

Would the leading edge of a wing be a good place for this cooling?

Would there be enough area?

I don?t believe there would be enough heat to effect aerodynamics of a wing.
  Speculation?

The ?D? section shape would fit best with a tube, therefore minimizing the
amount of pocofoam in a design.  It may also have an effect on icing.  Also,
if the cooling system sprung a leak, I'd much rather have it someplace else
than in the fuselage.


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org