Robert Barnard wrote:
Here is a far out question.
There have been a few attempts to cool an engine by
dissipating the
heat to
the skin of the aircraft. Could this be a viable
alternative to a
drag-inducing radiator?
James Russell wrote:
After the Italian seaplane racer in the '30s, Porsche tried
surface
coolers since their
bodywork was already alumnium by welding half-tubes to the
bottom side
of it.
I think the cracking and leaks stopped them.
Porsche will try anything: annular brakes, alumnium
tube-frames,
electron beam
welding cranks together...
> Would pocofoam work well to distribute heat from a rigid
tube to
the outer
skin of a wing or fuselage and be light and efficient?
> RB
The skin-to-PocoFoam part is what I'm curious about: alumnium
(corrosion),
brass/copper (heavy), carbon ( the fibers run normal to the
PocoFoam
plus it needs
350s cure epoxy which means a tool and oven), ? I emailed them
about
this, tho.
Regards,
James
Robert Barnard wrote:
Electrolysis would be a definite problem to workout, assuming it?s
necessary
to dissipate through aluminum skin. If aluminum were part of the
answer, a
thermally efficient bonding agent would be employed. It or other
material
(light fiberglass cloth) could be a barrier between the carbon and
aluminum.
Would the leading edge of a wing be a good place for this cooling?
Would there be enough area?
I don?t believe there would be enough heat to effect aerodynamics
of a wing.
Speculation?
The ?D? section shape would fit best with a tube, therefore
minimizing the
amount of pocofoam in a design. It may also have an effect on
icing. Also,
if the cooling system sprung a leak, I'd much rather have it
someplace else
than in the fuselage.
Lockheed L-188 used a tapered tube to take turbine
exaust out the wing. It had outlets facing foreward to
get the heat to the leading edge. DE-ICING method. Virg
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org