Subject: Question Re: pocofoam - Wing cooling
From: Paul
Date: 1/14/2001, 10:13 PM

:


        Lockheed L-188 used a tapered tube to take turbine
exaust out the wing. It had outlets facing foreward to
get the heat to the leading edge. DE-ICING method. Virg

Gaylen Lerohl wrote
The Lockheed C-130E uses bleed air off the compressor section of the
engines.  This 550 degree F air is mixed with ambient and recirculated air
to reduce its temp to between 158 and 180 degrees F.  It flows through
passages near the leading edges.  If the temps near the leading edge reach
200 degrees F it is considered an overheat condition.

There is probably more heat in the rotary's exhaust than needed for
anti-ice.  You would probably want to reduce the temps considerably before
circulating it near the skins.

Gaylen

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org