Leon Promet wrote:
Hi Tracey,
Maaaaaaaaaaaaaate, seriously, what was my point? Wasn't I warning people
about the dangers of WRONG MIXTURES and timing in TURBOCHARGED
applications.
Sure mate, you can get away with really silly timing advance and super
lean mixtures and ridiculously high EGT at cruise in a naturally aspirated
motor, and sure the engine is not working hard cruising at 10,000 ft.
Agreed! No contest ... But in a turbo engine, under boost, at ground
level on takeoff, it's a WHOLE different ball game.
So if, as you say, and I quote:
" This only happens with engine operation near the outer limits of BMEP or
RPM. This just never occures in the real world of aircraft operations. To
my knowledge, there is not a single example of an OPERATIONAL rotary
powered airplane that is even mildly turbocharged".
are you are telling me that nobody is actually running a turbocharged
rotary engine in an aircraft yet, and ADDITIONALLY, if they are, never at
or close to max BMEP, and therefore NOBODY really has experience in these
matters of turbo engines at takeoff?
The next thing I suppose you are going to tell me is that in any case, you
are not working the ring off an engine at takeoff/climbout, and therefore
my racing experiences are invalid?
OK, tell me Tracey, what's the difference between loading a 13B turbo up
on a 4,500 ~ 5,000 RPM stall torque converter (autos don't "miss shifts"
}:>), maaaaaaaaate), and then running a quarter mile drag in a car
weighing say 1000 Kg (10 ~ 14 sec depending on boost level) and doing a
similar thing in a 13B turbo powered aircraft weighing about the same mass?
Hmmmmm ... ? Isn't an aircraft on full noise for a lot longer at WOT than
my drag car, yet experiencing the same load?
If a drag race engine detonates and disintegrates, (and I've had quite a
few of them do that before the advent of 3D digital EFI engine management
systems), the driver simply knocks the gearbox into neutral, utters a few
expletives and coasts to a stop, whistles up the pit crew, tows it back
to the pits, swaps the spare engine and is back on the track within an
hour or so. No Wurries Mate!
Not really an option in an aircraft on a short strip when you are well
beyond V1 and just rotated and/or just airborne, or even worse, just
about to clear the tree-line at the end of the runway. As the Mitsubishi
advert says "Please Consider!"
Sincerely,
Leon Promet
Chuck Harbert had ten or so flights with his turbo 3 rotor. Brice Dunay in
Oklahoma City had a stock dual turbo three rotor in a canard. Brice reported
to me at Oskosh a couple of years ago (flew it in) no problems with the engine but the
gross weight was so far over design he had fuselage structural problems.
Overly heavy engine means more ballast in the nose means higher bending loads
in the fuselage. I think he had air conditioning and six way power seats
too :-). CJ Smale has 13B turbo's in his Rutan Defiant however no flight
reports so far.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org