Ken Powell wrote:
Question for Bill Freeman (and everyone else),
I was having a discussion with David Carter about the need for a
gascolator in an EFI low wing airplane. I started this conversation
thinking 'OF COURSE', but now I am not so sure when I try to look at
the facts. David summarized this better than I can, so here is his
post:
David Carter wrote:
When I propose not using a gascolator in an RV-6 (tail dragger) with
fuel injected 13B, the basis is this:
The outlet from each low wing fuel tank is 5 1/8 inches above the
aft corner of fuel tank when sitting in 3 point attitude on ground
(tail dragger).
Fuel has to be sucked out of each tank - there would be gravity feed
only for the top 1/2 of the tank and I won't have half a tank of
water. There is no way that fuel can settle to anywhere except the
aft inboard corner of each tank, which is where the fuel quick drain
is located. So that is where my water will settle and be found by
me on preflight - nowhere else. It can't get to the lines in the
cockpit or engine bay by gravity, so why have a gascolator?
David Carter
This should catch the water better tan a gascolator, and the EFI
fuel filters will do a better job of filtering than a gascolator.
So the question is, do we need a gascolator on an EFI, low wing tail
dragger?
Thanks,
Ken Powell
Bill Freeman wrote:
Ken,
I'm not sure I see why " where my water will settle and be found by
me on preflight - nowhere else." Why is this different than every
other airplane out there? Seems like some water may be undrained
at some time and it would be good to catch it before the injection
systems. Doesn't need to have a filter and water sump *combined*,
(gascolator) but I think you do need these two functions to be
satisfied somewhere. Remember, someday you might forget to
drain the tanks, and need a place to store that water for a few hours.
Bill
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org