Leon Promet wrote:
Hi Paul,
SNIP >>
You wrote:
"Simple. Factor in the fact that the apex seal oil supply also cools the
apex seals.
The bi metal effect of temperature distortion causes the apex seal to go
into a banana shape."
Yeah, but if the oil is cooling the contact edge of the middle of apex
seal, isn't it going to make the thing banana the WRONG way? Won't the
centre be low, and the ends be high?
Yes and my point exactly. That would indeed cause the wear problems we
are seeing. Over cooling the center of the seal.
My understanding of the original thrust of you introducing this particular
phenomenon was this wear was occurring because the oil distribution was
poor. It was therefore just another reason to support your "Get rid of
Metering Pumps 'coz burning Engine Oil creates lots of Gunk, burns the
crap out of the Crankcase and makes Apex Seals stick" thesis.
However, we are seeing wear in exactly the place where we would LEAST
expect to see wear, which according to your wonderful attached Gif (which
I heartily endorse) is the place of maximum oil flow. Where is the max oil
flow. Out of the metering pump oil hole! Where is the most wear. On the
oil hole meridian!! (Am I being too tedious??)
So how do you explain the presence of wear in exactly the place where you
would least expect it??
Interesting conundrum .... Perhaps it is not metal to metal contact that
is causing the wear/polishing marks? Maybe it's something else. I wonder
what that could be?? Have you had a look at the apex seals that came out
of this motor??
I'm told on good authority that there are only two basic things that cause
wear in engines. Metal to metal contact and what else?? Anybody got any
ideas? (Hint: what is an oil filter supposed to do??)
Sincerely,
Leon
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org