Subject: Trochoid Wear Patterns was RE: Injecting Sump Oil
From: Paul
Date: 1/17/2001, 1:29 AM

SNIP >>

 Probably what we are looking at is marks in the trochoid surface made
by a a wear pattern in the apex seal cause by uneven apex seal lube
distribution.

Paul Lamar



Leon Promet wrote:

Yair G'day,

It's Leon the Lunatic from the antipodes again.  Got some more questions
for you.

Tell me guys,  which part of the trochoid is worn,  and which part is NOT
worn.  C'mon,  easy question,  just get one of those 10x magnifiers.
 According to your theory,  the meridian on the oil hole should exhibit
LESS wear than the rest of the trochoid. True??

But what are we seeing?  That central area on the oil hole meridian appears
to be highly polished. Just like the very outer edges. Hmmmmmm ... Is it
due to metal to metal contact?  If so,  then that is totally opposite to
what theory predicts.

There should be less likelihood of metal to metal contact where the oil is
most plentiful.  The apex seals are obviously not conforming to the
trochoid anywhere except right in the centre meridian,  especially just
below the minor axis  which is evidenced by the brown deposits. Otherwise,
 why the polished ring?   Or is there some other explanation?

So what does that mean??  Wrong theory,  or wrong observations??  I can see
that this is going to be a duzzy!  C'mon,  thinking caps on!

Sincerely,

Leon

Simple. Factor in the fact that the apex seal oil supply also cools the apex seals.
The bi metal effect of temperature distortion causes the apex seal to go
into a banana shape. The rate of wear and friction is also a function of local 
temperatures along the apex seal. The center of the seal normally runs the hottest. 
The seal could be rocking back and fourth in the slot in a vibratory mode causing the 
chatter marks. All sorts of temperature effects could be going on
affecting the incremental  pressure, wear and friction of the seal on the housing  
as a function of its width.

Perhaps what you have in mind is the center of the seal wore out due to lack of 
oil and no longer exerted as much pressure on the housings as does its 
outer edges.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

apexOIL2.GIF