Another chart showing apex seal temperature as a function of oil volume.
BTW Jim Mederer at Racing Beat said up to four ounces of two cycle oil per
gallon of gas does not seem to cause detonation on his 900 HP turbo three
rotor.
Paul Lamar
Interesting chart about oil flow and seal temperature. It would tend to
show that we may use much more oil than necessary for cooling the apex
seals in our premix.. I was rather surprised at the relatively low flow
rate required for 6000 rpm WOT. Say you use the 100 cc/hr figure to give a
little margin for safe seal temperature, the for two banks total oil flow
would equal 200 cc/hr. For the 13B 6000 WOT at sea level would give approx
180 HP or around 16.5 GPH.
200cc/hr equals 6.7 Oz (US)/hr, or 6.7/16.5 =0.4 Oz/gallon of oil gasoline
mix. or a ratio of 325:1. I believe I recall reading that the auto
injection gives around 200:1, but even a 1 oz/gallon gives a 132:1 ratio.
It would seem that 1oz of oil per gallon would suffice for our use. Does
the increase to 4 oz /gallon represent a need or just a safety precaution??
Or is their something I am over looking??
Ed Anderson
Don't forget the 300 HP per rotor Jim is getting. That would be a 600 HP
13B.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org