Subject: 202 mph burning 8.25 GPH
From: Paul
Date: 1/18/2001, 3:02 PM

marc wise wrote:

What's the flat plate area of an rv-4?

That is a combination term. It is a short hand way of saying
saying the maximum cross sectional area times the drag factor. 
It assumes the drag factor or drag coefficient is one and  the
area is adjusted accordingly.

Lets say the maximum cross sectional area of the aircraft looking at 
it directly from the front  is ten square feet. You can measure this
by parking the aircraft in front of a large grid on a wall
and shining a spot light on the airplane from several dozen feet away.
This will cast a shadow on the grid and the squares in the shadow
counted giving the maximum cross sectional area. BTW this is
sometimes referred to as the frontal area. The term frontal area
is frequently misused to refer to the area of the cowl around the 
prop spinner. That is an incorrect use of the term. 

Therefore we have an airplane two feet wide by five feet high. If the drag
coefficient is 0.2 then the equivalent flat plate area is 2 square feet.

This is a simplification because we ignored the frontal 
area  of the wings and landing gear. For an RV4 this number is
around 2.5. A side by side airplane would have a higher number if
the drag factor was the same. Apparently the RV6 has a lower drag
factor than the RV4 because the drag is not that much higher.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org