"Kevin R. Walsh" wrote:
This may have been covered before, but what is the advantage to using
the turbo core if you are going to install the NA rotors? I'm only
asking because the time for me to start buying parts is coming soon,
and I thought I'd double check.
Also, if I decide to use a Peripheral port (which I think I will), I'll
be replacing the rotor housings anyway, so what would be the best core
to use then. I'm aware of the year differences, so that much (at
least) is clear....
Kevin
Some think the NA four port breathes better than a modified six port. I
don't agree.
After all the new RX8 engine will be a NA six port and it is getting
280 to 290 HP at 9000 RPM. That takes breathing.
I am trying to get someone to try grinding out the partition between
the two ports on the six port end housing. (Mine is a turbo engine
so I can just up the boost.)
The 93 and later turbo engines have stronger end housings as I understand
it.
Paul Lamar
Kevin,
If money is no object, use the gen 3 engine. Is it worth the extra $? Only
you can say.
I used the NA rotors on my turbo block to get a higher compression ratio.
(9.7 - 1)
I'm always torn when someone asks me about stuff like peripheral porting. I
like to see people experiment with different things and see how it turns out
but on the other hand, I want to see them successfully fly their airplane.
There are some potential advantages for peripheral porting but my bet is
that the pitfalls far outweigh the advantages for most builders. As they
say in Mexico, "With money, all things are possible". I would add time as
well to that saying. So do you have both time and money enough to go this
route?
Paul also has a point about the six port engine compared to the 4 port.
IF you do everything right, the 6 port may make more normally aspirated
power than the 4 port . Doing everything right is always the tricky part of
course. Only a lot of experimenting will tell us the final answer. If you
are looking for my "real world" opinion, it probably does not make a
nickel's worth of difference which way you go. Normally aspirated, the 6
and 4 ports are going to make the same power + or - 3%, all other things
being equal. The arguments about which is best is interesting for awhile
but mostly academic.
Tracy Crook
rws@altavista.net
www.rotaryaviation.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org