Subject: 202 mph burning 8.25 GPH
From: Paul
Date: 1/18/2001, 8:16 PM


BTW, the book numbers (160 HP Lyc) RV-4 are 204 top speed (sea level) and
194 cruise at 75% at 7,500 ft.  I'm doing a little better on top speed
(haven't checked it with the latest configuration) but it's around 210.

Tracy Crook
rws@altavista.net
www.rotaryaviation.com
Tracy,


Mike Wills wrote:

  Do you consider your prop to be a "cruise" prop or a "climb" prop? How
does your takeoff and climb performance compare to Vans book numbers? From
Vans website a 160 HP RV4 has a takeoff roll of 300 ft and a climb rate of
2050 fpm. That performance is solo probably with minimal fuel and doesnt
specify what type of prop (but I think the factory 160 HP RV4 prototype had
a CS prop). So maybe an apples and oranges comparison but I'm curious just
the same.

  While watching Chuck Dunlap fly around at Copperstate my impression just
watching was that he didnt have comparable takeoff/climb performance to the
Lyc powered RVs. Could have been due to the newness of the installation or
other factors. How about it Chuck, how does your performance compare to the
book numbers for an RV6?

  In the running of the Copperstate dash this past year there was a Chevy
V6 powered RV6 entered. In talking to the owner he was claiming 215HP if I
remember correctly. But his race pace was about 50 - 60 MPH slower than the
other RVs entered. So I dont know where that HP claim came from.

Mike Wills


  From the guy that sold him the plans!   HA !  No names, but a certain
widely know
purveyor of the Ford V6 for aircraft was at our field with his son to
observe the 1st
flight of a friend's Glassair 2 that had a few hundred hours on a 150 Lyc before
being switched to the Ford V6.   I watched and listened silently as they
discussed
why the prop was wrong, the exhaust was wrong, etc to explain why the
performance
was far lower than the 150 Lyc.   Ultimately, the guy switched back after
about 50
hours of trying to make it work.  Clearly much less power than the Lyc 150.
The Ford
V6 is darned heavy and most installations load the crankshaft dangerously
with the belt PSRU.
Not surprising that it is 50-60 mph slower.  Probably makes 1/2 - 2/3 the HP.

Bill

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org