BTW, finally got around to doing some performance measurements with
the new
engine & muffler combination. I was totally jazzed to find that at
14,000
feet I could cruise at 202 mph burning 8.25 GPH (WOT). Not bad for a
relatively dirty RV-4.
Tracy Crook
rws@altavista.net
www.rotaryaviation.com
Rino Lacombe wrote:
What are the specs on this engine muffler combination. Is it a
different engine?
Rino
Engine is a 89 turbo II with no significant porting. The turbo rotors were
replaced with 89 - 91 normally aspirated rotors (9.7 - 1 CR) for better BSFC
in non-turbo service. The oil pump is also a non turbo unit (for better
fuel economy, every bit helps). EC2 engine management system and RD-1A
redrive are used.
The exhaust system and muffler has been discussed at length already.
Approx. 30" headers into a 2.25" collector, then an Edelbrock RPM muffler
hung under the fuselage followed by 2.25" tailpipe out to a point behind
the rear seat passenger (for lower noise inside).
Tracy Crook
rws@altavista.net
www.rotaryaviation.com
IMHO If he streamlined that muffler with a bit of SS sheet he would go faster :-).
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org