> > Yes, and a digital EGT gauge is mandatory. The resolution on
analog
meters
is not good enough to get a really close match. I like to get EGT
differential less than 10 degrees at cruise conditions. Having only
two
(or
three on 20B) EGTs to match is another advantage of the rotary :-)
Tracy Crook
Tracy, you mention a digital EGT gauge, what is your source and price
for
such a gauge? My twin needle analog EGT gauge has always shown my two
rotors (on two different engines) to be approx 75F difference. No, I
have
not tried to enrich the lean rotor yet, as I suspect that the difference
could be sensor/gauge related since it appeared on both engines. Rear
rotor
showing the leaner condition (or is it richer) in any case its exhaust
temp
is the higher of the two.
Ed Anderson
Tracy Crook wrote:
I use the Grand Rapids EIS which is an all digital engine monitor. Yes, it
is very important to verify instrument accuracy before starting to screw
around with the mixtures. I'd at least try swaping the EGT probes around
and see if the same rotor still has highest reading. Another good point
you made is that the lower EGT may be either richer or leaner than the
hotter one. Use the manual mixture control to determine whether the cool
one is on the rich or lean side of peak before making adjustments. If you
have a large differential in EGT's with the default settings on the EC2
(injection pulse width equal) it may indicat a dirty or sticky injector or
an air leak in the manifold.. 75 deg F is more than I like to see but not a
sign of major problems. Main result will be higher fuel consumption since
you have to run the rich rotor richer than necessary.
Tracy Crook
rws@altavista.net
www.rotaryaviation.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org