Ed Anderson wrote:
>
Yes, Mike, I am down on power to maybe 150 HP. 153 Knot (170 MPH?) top
speed. I flew along side my 160 HP Lyc. RV-4 once and couldn't keep up.
I
need to change my prop or have it de-pitched. I am only turning 5500 RPM
at
max cruise. 4800 RPM take-off. I am thinking about getting an electric
adjustable Ivo Prop. So far, I haven't gone on any Long cross country
trips, so the top speed has not been all that important to me.
Chuck Dunlap
Chuck,
My 13B powered RV-6A with the 6 port gave me a top speed of 186 MPH TAS
(GPS Verified) . I initially estimated my HP to be in the 160 HP range. I
then did a very careful measurement of my fuel burn. By flying WOT off one
tank for 30 minutes using the other tank for take-off and landing. The
resulting fuel burn was 10.57 gallons/per hour. I was pretty pleased with
the great mileage until I realized it was the results of low HP. This works
out to approx 114 HP for the rotary at 8000 MSL. This translates in to a
sea level HP of approx 152 HP. This was with the engine in its peak
condition.
Later due to the faulty installation of an apex seal with overtime caused
sufficient scoring of the side walls to drop performance, the HP had
decreased due to the damage to around 130Hp before I stopped flying it and
changed engines. By this time the top speed had dropped to the 170 MPH
range. While in the air it was not that bad, mainly climb was slow and of
course top speed was down, but it was still 40 mph greater than the Pipes
and Cessnas I was use to flying.. However, where I really notice the lack
of HP was take off on hot days on short runways. Make for Looonggg take off
rolls and ROC had fallen to less than 1000 fpm.
If you really want to get a fairly accurate measure of your HP. Do a
carefully controlled timed fuel burn at WOT at 7500-8000 MSL. The computed
your fuel burn rate, multiply the Gallons/hour to turn it into pounds/hour
and then divided by 0.55 to get a fair estimate of your HP.
Best Regards
Ed Anderson
.
I think .55 BSFC is a bit high for a well leaned rotary. Not that it changes the
HP numbers all that much.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org