The jig I built is larger than this drawing shows so it could accommodate
a wide range of motor mounts for many different airplanes.
All you do is locate all the tube joint in space and they are held with the
perforated angle in a fixed relationships to each other rather than gravity holding
the engine in position relative to the fuselage. You can then flip it any which
way and tack or weld the joints in comfort.
BTW the mount design shown is different than the mount design I choose for the KIS.
When I get done with it I can loan it out if anybody is interested. Does not weigh much so
maybe it can be UPS's ground with a bit of cardboard wrapped around it.
It has taken me a couple of days and about $50 to $70 in material to make it.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org