Ken, how are you notching your tubing?

This Jancy tube notcher is real expensive I think.

http://www.jancyslugger.com/pipetube.htm

____________________________________________________________________________
Notch any angle 0° to 60° in any pipe
or tube (round or square) from 3/4" to 3" diameter in seconds to a
gap free fit ready for welding or assembly. 

The AL100 is ideal machine for production or short job runs,
eliminating the time consuming and costly process of fitting and
finishing pipe and tube joints. 

Using today's abrasive grinding belt technology the ALl00 is a safe,
cost effective alternative to using costly dies hole saws, end mills,
grinding wheels aud flame cutting torches to fit pipe and tube joints.
__________________________________________________________________________

I am leaning towards an angle vice and hole saw in the drill press.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org