Subject: vary the port timing with the throttle opening
From: Paul
Date: 1/22/2001, 10:14 AM


Ken Power wrote:

Kevin,
I am also building a PP engine for my RV-4.  Paul and I worked
out the following design in an effort to boost BSFC, add HP and
to maitain a smooth idle.  We are predicting 210 to 225 HP - no
way of knowing without dyno testing.  This is untested at the
present time, but I will be putting the engine together this
spring.  Note that Paul designed and built the variable intake
that makes this work.  The idea is to vary the port timing with
the throttle opening.  This will allow very mild port timing for
idle and part throttle operation, and aggressive port timing for
WOT.

Ken Powell


Too much to up load Ken so here is the gist of it.
One of the photos looks better upside down.

This is a little confusing.  I see how you have a valve that can adjust
throttle position and port timing.  Pretty good idea.   But you need to
seal that thing up.  It looks like it will leak air from just about
everywhere.  Your idle is going to be really high just based on the
amount of air leaking around the sides of your valve.  Do you have
another throttle?

Kevin


No! Only this one.

I neglected to mention Kevin there is a cover (yet to be made) that goes
over the back hole :-) Yes it will be sealed. It was designed that
way so it could be serviced. The throttle parts can be removed through
this back hole.

BTW As you mentioned about the idle unlike a carb system a little leak in 
an ECU controlled fuel injection manifold does not hurt. You just re-map 
it to adjust for the air leaks.

Here is another up side down picture. I rotated it so you could see the straight
shot into the rotor housing while gravity held the throttle plates wide open 
and "up". :-)

As you can see the seal is not perfect because of my machining limitations 
but it will work to prove the concept.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

stright-shot-in.jpg