Ed Anderson wrote:
Paul,
Here is the Harbor Freight tube cutter on sale
Ed Anderson
Thanks Ed I logged on to the web site and saw it. Pretty simple.
I will drop over to the warehouse/retail show room in the next
couple of days and look at it. I suspect rigidity is everything just
like any other metal cutting device so you cannot tell much
about that from a picture. The $26 device is bound to be junk.
Since the hole saw seems to be a problem
perhaps I can replace that with a drum sander and a slide base
on one of these devices for use with a drill press at high RPM.
I could also fasten it down on the mill table and use a drum
sander in the quill with protection from the grinding dust
of course.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org