Subject: vary the port timing with the throttle opening
From: Paul
Date: 1/23/2001, 10:34 AM

"Kevin R. Walsh" wrote:

I neglected to mention Kevin there is a cover (yet to be made) that
goes
over the back hole :-) Yes it will be sealed. It was designed that
way so it could be serviced. The throttle parts can be removed
through
this back hole.

BTW As you mentioned about the idle unlike a carb system a little
leak in
an ECU controlled fuel injection manifold does not hurt. You just
re-map
it to adjust for the air leaks.


Paul-

I'll have to disagree on this one.  I think for idle you have to seal
the throttle ramp.  For instance, let's say it leaks some air.  You
re-map your injector to provide less fuel.  Now the engine runs slower,
but you have effectively leaned the mixture way past peak.  So let's
say you suffer with the leak and add more fuel on the injector map at
idle.  Now you'll have a high idle.  I think the only way you are going
to get an acceptable slow idle is to seal it to the side.

All throttle schemes leak air.

We are talking only about several thousands of an inch here with a large flat
surface. That is not much of a leak. As I said my machining job is not
perfect and so we have a high idle on the prototype. It is not going
into a sea plane.

With that said, what is the advantage of the design you have made
versus a simple slide throttle placed at the entrance to the P-port
pulled in the up direction?  The only advantage I see is that the ramp
plate you have would smooth the flow into the port.  I'd argue that
this advantage is lost going from the rectangular manifold section to
the round P-port opening.

We obviously don't agree. We feel the velocity gained at the port is an advantage 
in mixing the air and fuel. I know of many manifolds that transition from square 
to round with absolutely no problems at all. Again what you see by looking
into the transition is not perfect. Perhaps a casting is called for or a little
smoothing with a port grinder. If it makes you feel better keep the
runners square all the way out to the plenum.

So, I guess my point is that you could get the same or better
performance, with a better idle, in a simpler system, if you used a
round manifold cross section and a slide throttle at the port.

I don't agree. Slide throttles leak too and the severe aerodynamic discontinuity
at partial throttle opening would negate these advantages.

Further more it is absolutely important to provide linear ball bearings on
slide throttles because the vacuum loads on them cause them to stick.
Consequently slide throttles are very expensive. A two inch bore slide throttle
has about 50 pounds of force on it with a suddenly closed throttle 
condition from moderate to high RPM. Ours does too but the shaft 
geometry minimizes the force on the throttle linkage. The shaft,
at worst, would require two low cost ball bearings.

Final question:  How far are your injectors from the port?  Are they
all the way back at the manifold entrance (~21") or are they at the
port?

I envision them all the way back for better BSFC in  aircraft use and right 
near the port for automotive use. Necessary for good throttle response.

P.S.  In the CAD survey, I'm a Pro/E user, but also have AutoCAD R14
and access to SolidWorks.  I prefer Pro/E for all modelling, AutoCAD
for electrical schematics, and have yet to play with SolidWorks enough
to make a decision.

=====
Kevin Russert Walsh
Sr. Process & Equipment Development Engineer

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org