Subject: Harbor Freight tube notcher
From: Paul
Date: 1/26/2001, 10:59 PM

Here is the back side of the tube notcher on sale.
I clamped it in a vice to stiffen it up a bit.
The basic structure is good with 3/8 inch thick 
plate. It had kind of a wimpy right angle bracket that 
you were supposed to bolt down to the drill press table. 
I'll show you the job it did next.

I did not buy the hole saw from them. I have had a lot of 
broken ratchet handles and extensions that I have bought from 
Harbor Freight. Their hand tools are not worth it.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Harbor-Freght-back-side-notcher.jpg