Subject: Harbor Freight tube notcher
From: Paul
Date: 1/26/2001, 11:15 PM

Here is the job it did. Not too bad. The secret is run the
drill press slowly and use a good quality metal cutting hole
saw. The little hole saw adapter that came with the unit had
some run out so you might want to have that fixed by a 
machinist. Typical of their stuff. There is always something
minor wrong. I had to take my HF bead blaster all apart and
seal all the joints with RTV.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Harbor-Freight-tube-notch.jpg