Subject: Ducted fan at Fox field
From: Paul
Date: 1/29/2001, 3:17 AM


Perry made it. 750 nautical miles and one stop in 7.5 hours. Right on schedule.
As soon as he taxied up to the transient tie down he drew a
crowd. Two of the onlookers are news letter subscribers.

Paul:  I just got home, just a quick note to let you know I made it back,
but now I have to go out for dinner, so won't get to read your email until
later.

Departed 8am with perfect skies, landed 2Q3 3 hours later right on
schedule.  Flew at 10,500.  From 2Q3 to MMV at 12,500, four hours.
Had a  tail wind in Oregon that helped.  Absolutely no clouds below
me the whole trip but there were some high clouds above me in Oregon.

More later...
--
Perry Mick
Duckt N7XR


vjaqua wrote:

Perry - Glad to hear that you made it back with minimum drama. My comment about the duct slowing you down was not meant as a slam. I do really admire your efforts and am pulling for your further success (you are doing - while most of us are "BS"ing). I have often thought about a direct drive fan project (with either a Wankel or a screaming 2 strok), for the same reason as moel aircraft - ie "jet fighter" syndrome I always thought a sort of scaled U-2 would be cool. One of the design areas that bugged me was - what should the exit tailpipe look like.  Most low speed ducts (and yours I believe) diverge at the exit like a venturi. My aerodnamic side of my brain (peanut size). tells me that should be wrong, because you are diffusing the flow to a lower exit velocity while you are still in the "contol volume" (airplane proper), and this must have an adverse impact on exit momentum. This would suggest that perhaps the duct should end at the trailing edge of the blades, or perhaps !
slightly converge. I think the Fantrainer had very little duct past the blades. For my U-2 I would be tempted to converge the tailpipe down to a value about equal to the effective working area of the"fan". I think most Fan Jet engines converge to accelerate the exit flow. These have very high power densities, and diffuse the entrance velocity in the inlet to reduce transonic losses and noise (the velocity thru the fan is probably lower than aircraft speed, and then utilize the pressure rise across the fan to accelerate the flow in the converging exit duct. - just some thoughts. - Vance


The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org