Subject: Ducted fan at Fox field
From: Paul
Date: 1/29/2001, 10:42 PM


Perry - Glad to hear that you made it back with minimum drama. My comment about the duct slowing you down was not meant as a slam. I do really admire your efforts and am pulling for your further success (you are doing - while most of us are "BS"ing). I have often thought about a direct drive fan project (with either a Wankel or a screaming 2 strok), for the same reason as moel aircraft - ie "jet fighter" syndrome I always thought a sort of scaled U-2 would be cool. One of the design areas that bugged me was - what should the exit tailpipe look like.  Most low speed ducts (and yours I believe) diverge at the exit like a venturi. My aerodnamic side of my brain (peanut size). tells me that should be wrong, because you are diffusing the flow to a lower exit velocity while you are still in the "contol volume" (airplane proper), and this must have an adverse impact on exit momentum. This would suggest that perhaps the duct should end at the trailing edge of the blades, or !
perh!
aps !
slightly converge. I think the Fantrainer had very little duct past the blades. For my U-2 I would be tempted to converge the tailpipe down to a value about equal to the effective working area of the"fan". I think most Fan Jet engines converge to accelerate the exit flow. These have very high power densities, and diffuse the entrance velocity in the inlet to reduce transonic losses and noise (the velocity thru the fan is probably lower than aircraft speed, and then utilize the pressure rise across the fan to accelerate the flow in the converging exit duct. - just some thoughts. - Vance


Vance, flying my plane is like flying a Cessna.  I like it when I get a tailwind
and get to go 140 knots!  I think my duct exit is too divergent at the exit, I
have a vent from the coolant overflow bottle to the top of the cowl, so if
the coolant overflow bottle is full and overflowing, at least I can see it.  So
a little coolant escapes once in a while and leave trails when it goes through
the duct.  The trails don't quite go to the trailing edge.  Probably air
separation going on there.

I tried the exit cone area nearly equal to fan plane area with duct3, but it
caused the engine to drag down and wasn't any faster as a result.  But with
more power it may work fine.  My HP is really low at the moment, around
120 is my best estimate.  So with a turbocharger and 150-175 hp I'll try
duct3 again.

I knew I would have a speed hit with the ducted fan, but it's just a little
more than I expected.  But at least it flies, better than the plane I had
before (none).  And I'm flying around with fewer moving parts than anyone
else in the world.
--
Perry Mick
Duckt N7XR
http://www.ductedfan.com

Perry - I agree - simplicity is the ultimate of elegance in design, and direct drive is a great goal.

 About the experience with the reduced divergence - did the speed drop relative to the rpm
 loss when the engine "bogged down" ? If not, this would suggest that you were going the same speed  at less HP? If so, then the approach might be less prop ( Pitch or blade area)?? Vance

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org