Subject: Universal motor mount jig
From: Paul
Date: 1/29/2001, 10:57 AM

The first picture is the mounting for the rubber motor mount
cup holder. No real problems there however since my
PSRU motor/mount plate is already made at 29 inches center to center
for the rubber mounts I had to slot the perforated angle to
get them in the right place.

The second picture is the mounting for the tube firewall
fitting. I was not happy with this as I had to slot the perforated
angle again and the single 5/16th  bolt will probably get in the way of 
fitting the MM tube. I will backup a bit and trade the perforated angle
for normal steel angle so I can drill a bunch of 1/4 holes
off center and mount the firewall fittings in the exact right places.
The perforated angle is fine for the frame but IMHO  solid
angle is better for the fittings mounts. Unfortunately solid
angle 2 by 2 by 1/8 thick is rather heavier than necessary.

If your motor mount is different and you want to borrow this jig
I would not recommend shipping the solid angle as the holes would be in the
wrong place for your mount (unless of course you had a Kis Cruiser) and 
the shipping would cost more than buying angle locally.

I have a lot more time in the R&D aspects of this jig than I suspected.
I sure hope it pays off when it comes time to actually weld
up the mount.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

cup-mount-on-jig.jpg

firewall-tube-fitting-jig.jpg