Subject: Ducted fan at Fox field
From: Paul
Date: 1/30/2001, 7:10 AM


Vance, flying my plane is like flying a Cessna.  I like it when I get a tailwind
and get to go 140 knots!  I think my duct exit is too divergent at the exit, I
have a vent from the coolant overflow bottle to the top of the cowl, so if
the coolant overflow bottle is full and overflowing, at least I can see it.  So
a little coolant escapes once in a while and leave trails when it goes through
the duct.  The trails don't quite go to the trailing edge.  Probably air
separation going on there.

I tried the exit cone area nearly equal to fan plane area with duct3, but it
caused the engine to drag down and wasn't any faster as a result.  But with
more power it may work fine.  My HP is really low at the moment, around
120 is my best estimate.  So with a turbocharger and 150-175 hp I'll try
duct3 again.

I knew I would have a speed hit with the ducted fan, but it's just a little
more than I expected.  But at least it flies, better than the plane I had
before (none).  And I'm flying around with fewer moving parts than anyone
else in the world.

Perry - I agree - simplicity is the ultimate of elegance in design, and direct drive is a great goal.

 About the experience with the reduced divergence - did the speed drop relative to the rpm
 loss when the engine "bogged down" ? If not, this would suggest that you were going the same speed  at less HP? If so, then the approach might be less prop ( Pitch or blade area)?? Vance


Since I used the same prop in both cases, duct2 accelerates the air by 30%, while
duct3 only accelerated it by 10%.  My full throttle RPM with duct2 is around 5400,
while with duct3 it was 5000.  But full throttle duct3 at 5000RPM was no faster than
duct2 at 5400.  So yes, same speed with less HP.  But I didn't like the takeoff and
climb performance of duct3, and didn't like the RPM drop and loss of power.
Duct3 may work better with a repitched prop (slightly less pitch), and I'm sure it will
work better when I have more power, to help takeoff and climb.

Duct3 is definitely faster for a given RPM, but it takes more power to get the same
RPM, assuming the same prop in both cases.

--
Perry Mick
Duckt N7XR
http://www.ductedfan.com

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org