Subject: EC2 and knock sensors
From: Paul
Date: 2/2/2001, 10:25 AM

marc wiese wrote:

Tracy,
You may have to contact J& S directly for their code and specs to design
for it. See below.
The 94 rx7 wiring connections are:
Pin D splice connection (into +12V wire between rx7 ecu and rx7 igniter)
Pin F (light green) between rx7ecu and the igniter is cut and fed "into and
out of" the J & S unit). This is the signal to retard the ignitor that is
processed by the J&S. Therefore the unit utilizes some base info in the car
ECU-
There is an optional connection to the MAP or TPS sensor to inhibit the
retard signal.
You may want to contact J&S directly:
PO Box 2199
Garden Grove, CA 92842-2199
Tel 714-534-6975
Their unit comes with an optional O2 readout on the display panel as well.
There is a newer model out just in the last few months.
Marc Wiese


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org