Subject: Tailwind fuselage rad. & cooling.
From: Paul
Date: 2/2/2001, 3:17 PM


Jerry Hey wrote:

Paul,  your previous comments generated a lot of thought on this end.
I am attaching a drawing that shows the (two day)  evolution of the
concept.  It is important to me to  not mess up the clean lines of
the Tailwind.  The little belly scoop would be almost invisible to
the casual observer.  I like it a lot more than my original side NACA
vents.

Your thoughts, please.     Jerry Hey

Here are my suggested changes. If you use a square plenum all the
air will try to go through the top of the rad.
You will also need a boundary layer bleed like a P51.
The air is not moving in the boundary layer. NACA ducts energize
the boundary to suck it in.

Paul Lamar

Mike Wills wrote:

Jerry,

  I assume from your drawing that you intend to use a radiator with a
water-oil heat exchanger for your oil cooler? If this is your intention I
recommend you make sure the radiator builder understands how much heat will
be dumped by the oil. I was looking into this a year or 2 ago and wasnt
able to locate such a cooler with enough capacity for the 13B. This could
be a pretty expensive mistake. I think these radiators with the built in
oil-water exchanger run near $1000.
  An alternative is a radiator/oil cooler combo that uses a conventional
air-oil exchanger but both the rad and the cooler are welded into the same
frame to form a single unit. Fluidyne sells these. The price is still
pretty high but they are a nice package.

Mike Wills 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org