Subject: Hurley Apex Seals and rotor grinding
From: Paul
Date: 2/3/2001, 8:13 PM

Hans Conser wrote:

I'm surprised that no one has chimed in for some Hurley seals.

Did I understand that you are going to visit them soon Paul?  Maybe we can save on shipping if you hand carry some seals back for us : )

I have seen rotors that are machined for 3mm seal that are not square, Hurley says that his grinding process solves this problem, maybe you can pick up some tips from him on how to do this (maybe for archie?).

I think engine builders would be happy to see better rotor seal slots and use more Hurley seals on this side of the [pond] as a result.  He is the only one I know of that makes 3.5 and 4 mm seals.

I assume you are going to buy the racing version in 3mm so you have some room for rebuilding?

Are you going to go with the direct seal lubrication modification?

Hans


Soon might be April. Maybe late March as I will be in Detroit protesting 
OBD III in early March.

The weekends are kind of slow around here. We will wait till next week.
Nah I was going for the whole hog at 3.5 mm.

I am in a quandary about direct seal lube. Emon Hurley says it works well but that
stuff out of the crankcase must be used.

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org