Subject: Turbo apex seal toughness.
From: Paul
Date: 2/3/2001, 12:04 AM


I think we are blowing this detonation/apex seal problem out of 
proportions. After all Abel Ibbara is getting many runs from his
700 HP turbo 13B and Jim Medere must have 100 hours dyno time
on his 900 HP turbo three rotors. There are lots of 400 HP 3rd gen
RX7's out there. IMHO the real potential of the rotary will not
be realized until somebody gets a turbo working in an aircraft
and explores the durability limits. That is what I am working on.

The power to weight ratio would then be unequaled by any piston
engine aircraft engine.

BTW I have decided to use my 88 turbo and manifold and see if
I can't salvage the them. Cracked 88 turbo's with good bearings and wheels 
and cracked manifolds are a dime a dozen and the much more durable 
89-91 setups are $1000.

I removed the flapper valve in this manifold by grinding on the end of the
shaft and I will weld up the cracks and weld on a gusset on the 
left to beef it up. I will also remove the cracked scroll divider in the 88 
turbo. These modifications should even out the heat distribution in the turbo
and the manifold. I will then inspect both the manifold and the turbo  
frequently for new cracks as these types of cracks tend not to be 
catastrophic.


Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

cracked-turboII-manifold.jpg