Subject: Turbo apex seal toughness.
From: Paul
Date: 2/4/2001, 6:53 AM


Hans...

Anybody up for a group purchase of some Hurley Apex seals and springs to
see if we can save some $?<<

Yep...count me in, too.  Good timing...I should probably be sure that I have
a set on hand when I open the engine later this month!

Harley

I am going for the wide 3.5 mm two piece type as I think they are tougher than the
2 mm for turbo use. We don't need the ultimate low leakage seal when running
at 5000 RPM  or above all the time. We are also not concerned with seal
jump over the hump due to high apex seal weight at 9000 RPM either since
we are limited to about 6500 RPM.

http://www.hurley-engineering.ltd.uk/

When we get everybody and the money together I will fly over standby and pick
them up. Ground out rotors too. Hopefully a little later in the year when the
weather is better over there. I have been meaning to visit  Hurley for quite
some time.

Emon,
What have you learned recently about apex seals for turbo engines
and detonation? Max ignition advance? Max boost?

Paul Lamar


Eamon Hurley wrote:

Ho Paul , thanks for the email,

You are all welcome to come and visit,

We have racer's making 900BHP+ on our 3m/m Race seals,

 We are now making our own springs, they are longer
, have a radius on the  ends which locates into the radius in the ends of the seals, 
this gives better overall control of the seal when passing over the hump. 
It seams to work ?

Please note , the weight of the seal is not really a factor , NSU engines 
use 5m/m seals , I used to drag race one which used to rev to 12K .

Keep up the good work .

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org