Harley wrote:
I am going for the wide 3.5 mm two piece type as I think they are tougher
than the 2 mm for turbo use. <<
Since I'm going with an NA engine for the time being (sticking it back in
the car for a year or two) would the wider seals be a good choice for this
too? Will they require machining of the seal slots?
Harley
Probably not worth it Harley. The stock seals seem to work fine for
NA. Yes the 3 mm or 3.5 mm need grinding the rotor slots.
Emon, as usual, did not give me a direct answer on the knock durability of
his 3 mm apex seals. I guess I will just have to go and talk to Able
Ibarra again and see what kind of experience he has had with detonation
and apex seals lately. Jim Mederer just says "don't let it detonate!!!".
I still think the best detonation prevention as opposed to detection is
limit or monitor the intake manifold temperature just like our fathers
did when they were flying P38's in WW II. That is what I intend to do.
Perhaps have Tracy's computer back off on the boost or the timing
if the turbo intake manifold temperature goes over 150 degrees F or so.
Knock is a very strong function of intake manifold temperature and
intake manifold temperature is a strong function of boost pressure.
If the ambient air temp is such and the boost pressure is such and such
the intercooler may not able to keep the intake manifold temeprature
below 150 F.
As I recall Tracy is already monitoring the intake manifold temperature
for the proper amount of fuel to be injected.
Of course that will not affect the boost pressure regulator either
so that will still function.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org