Hans...
Anybody up for a group purchase of some Hurley
Apex seals and springs to
see if we can save some $?<<
Yep...count me in, too. Good timing...I should
probably be sure that I have
a set on hand when I open the engine later this
month!
Harley
I am going for the wide 3.5 mm two piece type as I
think they are tougher than the
2 mm for turbo use. We don't need the ultimate low
leakage seal when running
at 5000 RPM or above all the time. We are also
not concerned with seal
jump over the hump due to high apex seal weight at
9000 RPM either since
we are limited to about 6500 RPM.
http://www.hurley-engineering.ltd.uk/
When we get everybody and the money together I
will fly over standby and pick
them up. Ground out rotors too. Hopefully a little
later in the year when the
weather is better over there. I have been meaning
to visit Hurley for quite
some time.
Emon,
What have you learned recently about apex seals
for turbo engines
and detonation? Max ignition advance? Max boost?
Paul Lamar
Eamon Hurley wrote:
Ho Paul , thanks for the email,
You are all welcome to come and visit,
We have racer's making 900BHP+ on our 3m/m Race
seals,
We are now making our own springs, they are
longer
, have a radius on the ends which locates into
the radius in the ends of the seals,
this gives better overall control of the seal when
passing over the hump.
It seams to work ?
Please note , the weight of the seal is not really
a factor , NSU engines
use 5m/m seals , I used to drag race one which
used to rev to 12K .
Keep up the good work .
DENIS SMITH wrote:
Paul, how would the Hurley seals work at 7 or 8
thousand rpm, or do you know?
I am sure they work up to or over 10,000 RPM because that is
what the drag racers are using. Emon also mentioned his NSU RO80
engine in his drag bike going over 12,000 RPM with 5 mm apex seals.
That was no small rotary engine.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org