Subject: Non rotary: welding 4130
From: Paul
Date: 2/6/2001, 12:43 PM


 > Peter Cowan/Lexi Cameron wrote:

 Would any of you who are experts on this please give me your comments?
 I'm concerned about distortion issues when I re-weld my fuselage.
The front half of the fuselage is bolted to the concrete basement
floor. About half way back I have cut through all tubes except the
lower longerons. I have removed enough material from the top
longerons and diagonals  to allow me to raise the tail end about 3
inches. (Didn't like the lines of it the other way plus the stab
needed more negative incidence.) I may tack it myself but I am
bringing in an expert with either his tig or mig welder. (His tig
welds are gorgeous on thin wall tube but the machine weighs about
300lbs and I may not be able to move it into the basement for him.)

 At this point the tail is not held rigidly except in its' distance
off the floor. Is there likely to be a lot of distortion as it is
welded?
 > Thanks for any tips you might have.

Jerry Hey wrote:

Clamp the tailpost dead center and vertical.  Clamp the firewall
station dead center and vertical.  The relative alignment of these
two is critical. What happens in between is not so critical, but you
should lay out a center line (string between tailpost and center of
firewall) and either square up from it or plumb down to it at each
station. Maintain the best alignment you can at every station.   Tack
each station all the way around before moving on to the next working
back from the firewall. Stay away from the MIG. It will not deliver
aircraft quality welds.  TIG or Oxy/actyl are the two choices.
Jerry

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org