Subject: Non rotary: welding 4130
From: Paul
Date: 2/6/2001, 11:36 AM

Peter Cowan/Lexi Cameron wrote:

Would any of you who are experts on this please give me your comments?
I'm concerned about distortion issues when I re-weld my fuselage. The front half of the fuselage is bolted to the concrete basement floor. About half way back I have cut through all tubes except the lower longerons. I have removed enough material from the top longerons and diagonals  to allow me to raise the tail end about 3 inches. (Didn't like the lines of it the other way plus the stab needed more negative incidence.) I may tack it myself but I am bringing in an expert with either his tig or mig welder. (His tig welds are gorgeous on thin wall tube but the machine weighs about 300lbs and I may not be able to move it into the basement for him.)

At this point the tail is not held rigidly except in its' distance off the floor. Is there likely to be a lot of distortion as it is welded?
Thanks for any tips you might have.

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Peter-Cowan-fuselage.jpg