The 6" tube is fine, but I'd bet a chunk of change that the end
brackets are flexible enough that your mount will move enough
to make it hard or impossible to reassemble after welding.
This stuff will move a LOT. Getting .060" movement or more
is common. Either weld in place or drill in the mounting holes
after welding is all done. Even heating of the whole mount
helps a bit, but these things just *move*. Can be pretty frustrating.
Exhaust systems do it, too. Pain the butt. I have given up
and do all final welding *tightly* bolted in place. Even then,
my exhaust needs to be tapped on and off of the studs. It fit
perfectly before the final welding.
Bill
Long EZ builder & pilot
mechanical engineer
You could go up on the thickness of the angle or use channel instead.
My box jig or fixture did not work out as it was too hard to weld the joints.
This is what I wound up with. I had to cut my fixture down so I could get
to the joints for welding. Are you using tig Bill? Tig is supposed to use
less heat. BTW as you tack weld in the tubes the fixture gets more rigid.
Jerry Hey's suggestion of putting the grinder or belt sander right next
the fixture is right on and extremely important. I must have ground or sanded
on the ends of those tubes two to three dozen times. Thanks Jerry.
Paul Lamar
No, I use oxy-acetylene. The only thing about TIG is to be *very*
sure you get full penetration. It is easy with MIG or TIG to make
beautiful welds with very little penetration. This is very dangerous.
TIG is wonderful, and does reduce distortion. Just be sure your
welder is *actually* good - certified is best because they have had
the benefit of having their welds X-rayed and really do know how
to do it right.
I strongly recommend that you grind all contact edges back at a 45
degree angle to force the weld bead to refill this angle and ensure
full penetration. This is proper weld practice but you can get away
without it when doing gas welding if you are practiced. I hate to
sound like a broken record but - AC43.13-1B ( I think this is the
new replacement for my AC43.13-1A & 2A) has a LOT of good
info on welding and repairing tube structures to proper strength
levels. A "MUST HAVE" reference for homebuilders. Chapter 2.
Make a few practice tube clusters with 1/2" conduit (cheap! altho
it puts off nasty galvanize fumes - weld outdoors and don't breath it) and
then hacksaw it apart and inspect your penetration. You can also
get a feel for the distortion potential. Doing three or four cluster
weld sets will really make you a lot better at welding tubing. Well
worth the time and trouble.
Bill
Long EZ builder & pilot
mechanical engineer
I am not good enough to do it myself Bill. The guy that will weld
my motor mount makes helicopter fire bomber drop tanks for most of the world.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org