Subject: Universal motor mount jig
From: Paul
Date: 2/6/2001, 2:29 PM


 > >My first design (first gif) has proven to be less than ideal.
 >The problem is I can't get my head far enough inside to see
 >the weld with my bi-focal glasses  due to the size of
 >the welding helmet and the diagonal braces. I can weld some
 >of it but I will have to take the motor mount out of the jig
 >to finish welding it.
 >
 >Here is my suggestion for model two. Make a sketch and take it
 >to your local welder and have him cut it out and welded up.
 >Lot easier for him as he probably has a cutting torch
 >and an iron worker.
 >
 >This is an inside out jig. The six inch
 >diameter steel tube is torsionally rigid so the 2 inch by 2
 >inch by 1/8 angle are held in the right positions.
 >Then the firewall and rubber motor mount 4130 steel brackets are
 >bolted to the ends of the angles. This way there is plenty
 >of room around them for welding the 4130 motor mount tubes.
 >
 >A true universal design would have telescoping tubing so the
 >length could be adjusted for any position of the rubber
 >motor mounts on the engine.
 >
 >Paul Lamar

 The 6" tube is fine, but I'd bet a chunk of change that the end
 brackets are flexible enough that your mount will move enough
 to make it hard or impossible to reassemble after welding.
 This stuff will move a LOT.  Getting .060" movement  or more
 is common.  Either weld in place or drill in the mounting holes
 after welding is all done.  Even heating of the whole mount
 helps a bit, but these things just *move*.  Can be pretty frustrating.
 Exhaust systems do it, too.   Pain the butt.  I have given up
 and do all final welding *tightly* bolted in place.  Even then,
 my exhaust needs to be tapped on and off of the studs.  It fit
 perfectly before the final welding.

 Bill
 Long EZ builder & pilot
 mechanical engineer

You could go up on the thickness of the angle or use channel instead.
My box jig or fixture did not work out as it was too hard to weld the joints.
This is what I wound up with. I had to cut my fixture down so I could get
to the joints for welding. Are you using tig Bill? Tig is supposed to use
less heat. BTW as you tack weld in the tubes the fixture gets more rigid.

Jerry Hey's suggestion of putting the grinder or belt sander right next
the fixture is right on and extremely important. I must have ground or sanded
on the ends of those tubes two to three dozen times. Thanks Jerry.

Paul Lamar


Jerry Hey wrote:

All of us have been there when it comes to getting our helmeted heads
into tight places. Bifocals really complicate things.  Go down to the
drug store and buy a set of reading glasses the same strength as your
bifocals.  You wear these whenever you weld.    Makes a big
difference when you can see what you are doing.  If you recall, I
suggested just welding with  the torch as it is easier to manipulate
in tight areas.  Now, you understand what I was talking about.
Bill's comments are right on.  Everything has to be bolted down all
the time.  I will post pics tonight of my engine mount fixture.  Jerry


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org