Subject: Water oil heat exchangers.
From: Paul
Date: 2/6/2001, 2:33 PM


You would be better off with separate radiators. The heat transfer from oil to water in that radiator is designed for a piston engine that has a different
heat balance than a rotary. In other words less of the cooling is done by the oil in a piston engine.

David Doshay wrote:
After what happened to Chuck Harbert I would not touch a Griffin product, but just for a point of reference, Mazda Racing sells an oil to water radiator. Cost: about $3k.

David--

I have been beating on a Griffin aluminum radiator in the race car for 5 years, including plugging an outlet and adding another. No problems. I have not seen a Griffin oil radiator even advertised.
 Lynn E. Hanover

Likewise,  I have a little Griffen rad that was used on a turbo-suzuki.  Only ran on the ground and was never flown.  However, the rad is a fine piece of work.  Griffen in-rad oil coolers are in their catalogue with the racing radiators.---Jerry


I should have mentioned this sooner, but I tried the oil to water cooler deal. I have a big Callies (the crankshaft people)oil to water exchanger. It works fine.
It is also heavy and it dumps a ton of heat into the water. It makes you need a bigger, heavier radiator.
I now have three Setrab oil coolers. Two in series in the scavenge side and one in the pressure side. No problems.  Lynn E. Hanover

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org