> You would be better off with separate radiators. The heat
transfer from oil to water in that radiator is designed for a piston
engine that has a different
heat balance than a rotary. In other words less of the cooling is
done by the oil in a piston engine.
David Doshay wrote:
After what happened to Chuck Harbert I would not touch a Griffin
product, but just for a point of reference, Mazda Racing sells an
oil to water radiator. Cost: about $3k.
David--
I have been beating on a Griffin aluminum radiator in the race car
for 5 years, including plugging an outlet and adding another. No
problems. I have not seen a Griffin oil radiator even advertised.
> >> Lynn E. Hanover
Likewise, I have a little Griffen rad that was used on a
turbo-suzuki. Only ran on the ground and was never flown.
However, the rad is a fine piece of work. Griffen in-rad oil
coolers are in their catalogue with the racing radiators.---Jerry
I should have mentioned this sooner, but I tried the oil to water
cooler deal. I have a big Callies (the crankshaft people)oil to
water exchanger. It works fine.
It is also heavy and it dumps a ton of heat into the water. It
makes you need a bigger, heavier radiator.
> I now have three Setrab oil coolers. Two in series in the
scavenge side and one in the pressure side. No problems. Lynn E.
Hanover
This is the reason I originally wanted a much larger radiator. I
simply added the ideal core areas of the radiator and the Mazda oil
cooler together, added 100 cu in for good measure and came up with
1000 cu in to handle all the cooling. Maybe my thinking is wrong in
this. Seems too simple. Anyway, the single rad does not weigh as
much as separate rads and an oil cooler and I still am hopeful of a
clean installation in the fuselage. Thanks for your imput. Jerry
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org