This is the reason I originally wanted a much larger radiator. I
simply added the ideal core areas of the radiator and the Mazda oil
cooler together, added 100 cu in for good measure and came up with
1000 cu in to handle all the cooling. Maybe my thinking is wrong in
this. Seems too simple. Anyway, the single rad does not weigh as
much as separate rads and an oil cooler and I still am hopeful of a
clean installation in the fuselage. Thanks for your input. Jerry
The point was that the combination oil and water cooler that would work well for a piston engine, may not have enough oil cooling capacity for the rotary. the Callies oil to water cooler is just a good size oil to air radiator enclosed in a box with coolant going through it. The only combination coolers I have seen just had two loops of aluminum tubing running through one of the end tanks. If more oil cooling were needed from one of the combination coolers, another set of loops could be added to the other end tank. I think it would work just fine. You could even cut off the end tank of a cheaper Griffin radiator ($169.00) and add your own oil radiator, then weld the tank back on. Leave a flange of 1 1/2" around the epoxy and keep wet rags on it while you weld. I would add a aftermarket electric fan, for those long ground run ups. Lynn E. Hanover
Epoxy? Are all Griffins epoxied Lynn?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org