Subject: Bell shapped inlet ducts
From: Paul
Date: 2/9/2001, 12:47 PM

Here is my crude, two dimensional verification of Kuchemann & Webers
contentions on bell shaped ducts. I used a handheld digital wind
speed meter to verify the flow uniformity coming out of the back side
of this radiator. It does indeed work. If you use a simple wedge
shaped duct most of the air will flow out of the sharp end 
of the rad. 

Tracy is using a simple wedge duct on his oil cooler and it is working
but he stuffs some porous foam in the sharp end to even out the airflow.
There is a slight aero drag penalty doing it this way.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

test-duct-Mikey.jpg