Subject: Carbon-Carbon Apex Seals
From: Paul
Date: 2/9/2001, 11:52 AM


Will the 4mm ceramic apex seals solve the knocking concerns?

Just wondering
Chris


I don't think so. Ceramic seals are brittle and can be broken with
finger pressure alone. I personally am going with Hurley Engineering apex
seals as they are softer and probably tougher than the Mazda cast iron or
ceramic seals not to mention a whole lot cheaper.

Paul Lamar

Mark Steitle wrote:

A non-rotary friend (of which I'm working on converting him to rotaryism) recently mentioned a space-age substance called carbon-carbon as a possible choice for apex seals. If I understood him correctly, it is made by baking carbon-fiber/epoxy at very high temp, then re-coat and bake it again until you have a chunk of carbonized material big enough to make a part from. It is supposed to be very low friction, durable and stand high heat applications very well. Because of the labor intensive nature of the manufacturing process it is rather expensive for fabrication of large parts. But, considering what we pay for apex seals, it could prove cost effective for rotaries.

Anyone have any experience with this material?
 Mark Steitle


The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org