Will the 4mm ceramic apex seals solve the knocking concerns?
Just wondering
Chris
I don't think so. Ceramic seals are brittle and can be broken with
finger pressure alone. I personally am going with Hurley
Engineering apex
seals as they are softer and probably tougher than the
Mazda cast iron or
ceramic seals not to mention a whole lot cheaper.
Paul Lamar
Mark Steitle wrote:
A non-rotary friend (of which I'm working on converting him
to rotaryism) recently mentioned a space-age substance called
carbon-carbon as a possible choice for apex seals. If I
understood him correctly, it is made by baking
carbon-fiber/epoxy at very high temp, then re-coat and bake
it again until you have a chunk of carbonized material big
enough to make a part from. It is supposed to be very low
friction, durable and stand high heat applications very well.
Because of the labor intensive nature of the manufacturing
process it is rather expensive for fabrication of large
parts. But, considering what we pay for apex seals, it could
prove cost effective for rotaries.
Anyone have any experience with this material?
Mark Steitle
I used to work for a small company in Maryland called Refractory Composites.
We made carbon/carbon and carbon/silicon carbide composites for spacecraft
heat shields and satellite thrusters. THe material is excellent-basically
the strength and density of aluminum but can handle extremely high
temperatures (>1200deg C), even in air. We made sheets 1'x 4' from layers
of carbon fiber which were deposited with either pyrolytic carbon or silicon
carbide. THe fibers are less stiff than the matrix, unlike traditional
composites, and serve to blunt crack growth and increase the toughness of
the ceramic. THis *IS* the material you'd want for an apex seal, but it
would be exorbitantly expensive ($1000 per seal perhaps). But it might
survive detonation and save your engine.
Now that I think about it, they might be in a position to make seals out of
the bits of scrap left over from large panels, and have a diamond surface
grinder to make the right thickness.
One of the engineers was also a '93 RX-7 owner.
Hmmm.... maybe I should give them a call.
Steve Rosine
Mustang II/13B
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org