Your thinking is not too simplistic. If you are going to go with a
water-oil exchanger you will need to increase rad core size.
Just to be sure that we are on the same page, you are talking about a
water-oil exchanger built into the radiator tank rather than the stand
alone water-oil type like the Callies cooler that Lynn mentioned. Is this
correct? If so I say again, be very sure that the radiator manufacturer
understands how much heat needs to be extracted from the oil. The radiator
core size isnt the only issue here. You must also consider the size of the
exchanger built into the radiator. Fred Moreno and I checked with Griffin,
C&R Racing, and Fluidyne who all make these types of radiators for racers
and as of last year none of them built such a radiator that we felt had
sufficient oil cooler capacity for the application. You may find out that
you need to run a second oil cooler (conventional air-oil) to take up the
slack.
Last week Ken Powell posted a summary and chart that showed an analysis
of the cooling situation for my RV4. Amongst all the data shown there is a
number for fuel energy in BTU/hr. I believe there is also a number for the
% of energy dumped into the coolant (both oil and water). The commonly
accepted assumption is that 33% of the cooling in a Mazda rotary is in the
oil. So some simple math should get you the heat load that needs to be shed
by the oil cooler. Take that number and give it to the radiator
manufacturer and see what they tell you. I can't recall off the top of my
head what that number was and don't have that chart handy but if you still
have it take a look.
> Mike Wills
Mike thanks for your comments. The rad/oil cooler combo I was
planning on is the same rad used on the NASCAR BUSCH Grand National
cars. I don't know how much HP they produce but it is a lot more
than my 200 (in my dreams) max. I figured, if it worked for them,
surely it would work for me. Like you say, I can always supplement
this system with another oil cooler if necessary.(Come to think of
it, I don't know that the rad/oil cooler is the only oil cooler in
the BUSCH cars.) Does anybody out there have the full picture on how
these cars cool their oil?) I'm still very happy to have enough
space to be talking about these options.
Jerry
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org