Subject: Carbon-Carbon Apex Seals
From: Paul
Date: 2/10/2001, 9:20 PM



I used to work for a small company in Maryland called Refractory
Composites.
We made carbon/carbon and carbon/silicon carbide composites for
spacecraft
heat shields and satellite thrusters.  THe material is
excellent-basically
the strength and density of aluminum but can handle extremely high
temperatures (>1200deg C), even in air.  We made sheets 1'x 4' from
layers
of carbon fiber which were deposited with either pyrolytic carbon or
silicon
carbide.  THe fibers are less stiff than the matrix, unlike traditional
composites, and serve to blunt crack growth and increase the toughness of
the ceramic.  THis *IS* the material you'd want for an apex seal, but it
would be exorbitantly expensive ($1000 per seal perhaps).  But it might
survive detonation and save your engine.
Now that I think about it, they might be in a position to make seals out
of
the bits of scrap left over from large panels, and have a diamond surface
grinder to make the right thickness.

One of the engineers was also a '93 RX-7 owner.

Hmmm....  maybe I should give them a call.

Steve Rosine

Mustang II/13B


That's how it all starts -I guess
George (down under)

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org