Subject: Report on Ed Anderson airplane
From: Paul
Date: 2/10/2001, 3:50 PM


Ed, How is the airplane flying? I am kind of curious on the power.
What size throttle body did you say you were using? What is the manifold
pressure on takeoff? Field elevation?

Paul Lamar


Hi Paul,

    Airplane is flying fine.  Still trying to sort out what the power
situation is.  I continue to turn 5600-5800 rpm on static run up with the
68x72 prop.  Max rpm in the air was between 6100-6200.  Jim Mosur lent me
his prop 68x78 which is approx 1.25" broader in chord than my prop.  He gets
a static of 4800 with his prop while my engine spun his 5400 static.
However, I could only get 5800 rpm in the air max out which is the same as
Jim gets.

So, it appears that my engine puts out more power in the 5500 range but
seems to slack off at higher rpm. However, I guess 6100-6200 is not bad.
Top speed was 186 MPH TAS (need to verify this with GPS) at 1650 lb. max
gross weight.   This may be the result of too much static ignition advance
for best power at higher rpm range.  I reset the ignition and will try to
fly it this week end to see what the effect is.

  The engine is clearly producing considerably more power than my old 86,
take off roll is approx 25 % shorter and ROC is around 1200 fpm.  Only have
two 30 minute flights in it thus far..

  Also it appears that the $64 I spent on the high performance seal [Ross PSRU] was
wasted money.  Both Sigurd Gandswindt (13B on a Glastar) and I  installed
the same seal, he reported that his seal had practically disintegrate after
15 hours.  I replaced my seal yesterday as I was getting a leak that while
small seemed to be getting worst. I noticed the white Teflon insert was
loose.    Sigurd used Mobile Synthetic and I used mineral oil so that did
not seem to be a factor.  So back to the cheap $8 national seal.

  It appears at this time that I will make Sun & Fun.

  Using the stock Mazda three port throttle body (holes approx 45 mm dia).
Take off Manifold pressure is 28.5 " Hg field elevation 565 feet.

Ed Anderson


I think the intake manifold pressure is a bit low. I would need to see the
barometric pressure for that day. Perhaps your air cleaner is the problem.

Ed could the input shaft and sun gear have some sort of run out? Have you put it
in V blocks and checked it with a dial indicator? Tracy also noticed some weird
wear on his Ross that could have been caused by run out in the input shaft
sun gear combination.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org