Hans Conser wrote:
"Hi Guys, Just got off the phone with Eamon Hurley. We can get a 25%
discount ordering 5 or more sets. This discount also applies to the
springs....... He strongly recommended 3mm racing seals for aircraft use.
He said there really was no gain to be had by going to the 3.5 mm, that is
for when you damage the rotor that is ground out to 3mm. The non racing
tip seals are a good low cost option for a street car.
"
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Hans,
I definitely want a set of Apex Seals for my 20B, but I'm hoping to get a
little information from you and the group first. My 20B engine just arrived
and I will be picking it up from the shipping company in a couple of days.
Until now, I've been trying to collect all the information possible in
preparation for its arrival. I have never seen or worked on a rotary engine
before (although I have extensive experience with piston engines) so please
excuse me if this sounds very elementary or plain stupid:
First, I was not planning to have my rotors machined for 3mm Apex Seals. I
heard from several builders that it was not necessary, and I was all for the
idea of trying to avoid the additional machining and shipping cost that it
would take to have this done. Can someone tell me what is to be gained by
going to 3mm Apex Seals for an aircraft application? Is it really worth
doing? How does the Hurley Seals compare to what you can buy locally at say
Atkins or Mazdatrix? Are the apex seals the same as what you are calling the
tip seals?
Second, is it typically necessary to replace the side seals. If so, what is
the best source for these, or, do they come as a set with the Apex Seals?
Third, what else will I need to rebuild my 20B assuming that the housings and
rotors are all OK? I'm assuming a gasket set and the Apex Seals, but what
else should be replaced while I'm in there? Do the bearings typically need
to be replaced?
I would appreciate any info that the group members can provide!!
Hans, I will send you an order as soon as I hear from the group about 2mm
versus 3mm seals. I really appreciate your effort in coordinating this group
purchase and it would really be great if it were possible for other items in
the future.
Thanks again in advance!!!
Sincerely,
Don Mitchell
Dallas, TX
Velocity Std-FG / 20B
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org