Subject: Report on Ed Anderson airplane
From: Paul
Date: 2/12/2001, 2:42 PM


  Also it appears that the $64 I spent on the high performance seal [Ross
PSRU] was
wasted money.  Both Sigurd Gandswindt (13B on a Glastar) and I  installed
the same seal, he reported that his seal had practically disintegrate
after
15 hours.  I replaced my seal yesterday as I was getting a leak that
while
small seemed to be getting worst. I noticed the white Teflon insert was
loose.    Sigurd used Mobile Synthetic and I used mineral oil so that did
not seem to be a factor.  So back to the cheap $8 national seal.

So is anyone making their own seals !?.
I eventually contacted  Dow Corning for my requirements -
pourable /castable seal material  and it seems code 736
-heat resistant to 260 degree C and code 735 heat resistant
to 210 degree C, will (it seems) meet my neads.

Don't know if it will help anyone !! ??

George (down under)

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org